Addition - First and Second Floor Addition

  • 11_02_07_478
    This is modular first and second story addition on the North Shore of Long Island. The demolition, underpinning, and site construction was extremely difficult. The unique and challenging modular design of the first and second floors including the porch area was an incredible accomplishment. I want to thank all people involved including the homeowners, the architect, and the entire staff at Pinecrest Modular Homes and Signature Building Systems. Jonathan Davidson President
Powered by TypePad

Energy Star Program - On Site Responsibilities

February 07, 2008

Energy Star Program - On Site Responsibilities

ENERGY STAR CONSTRUCTION REQUIREMENTS FOR SITE INSTALLATION 

           Pinecrest Modular Homes Inc. – On Site Responsibilities 

By completing the following tasks Pinecrest Modular Homes is able to comply with Energy Star certification requirements.

A. Marriage Line Seal. The marriage line areas must be filled with a continuous non-porous insulating gasket creating a permanent air barrier at joints in the ceiling, walls and floor. Acceptable gaskets can be one or two-part systems, including proprietary gaskets, foams, insulation wrapped in poly, and insulation covered by butyl or other long-life tape on one side. In addition, there must be no visible signs of gaps or tears. 

B. Tears in Bottom Board Material Repaired All tears in the bottom board material must be covered and sealed with a durable, permanent patch to prevent air leakage. (Foam sealant can be used on lag bolt and other small holes.) 

C. Exterior (Including Crossover) Duct Installation For multi-section homes, the exterior ducts must be sealed with a permanent connection per the Manufacturer's Installation Manual. Identify that the following items are completed: All exterior ducts have been installed and wrapped with insulation. Crossover collar is secured to the trunk with at least three screws and cannot rotate or move. All exterior duct insulation is a minimum of R-_______. Nylon or metal straps and saddles are used to support the exterior duct; duct does not touch the ground. Three or more screws are placed below the straps through the flexible duct and into the crossover collar. Exterior duct insulation is pushed into the floor cavity and sealed with tape or foam sealant at all bottom board penetrations. 

D. Field Installed Heat Pump Heating equipment efficiency meets or exceeds the following specification: HSPF-_______. E. For Homes Installed Over Basements (One of the following must be checked) This home has an UNHEATED BASEMENT. All interior stairwells from the heated space into the basement are constructed in the same manner as an exterior wall with full insulation and a weather-stripped, insulated exterior door. This home has a HEATED BASEMENT. The basement wall insulation level is a minimum of: R-_______.

 

eXTReMe Tracker